Lead-acid battery with its simple manufacturing process, raw materials, abundant source of affordable power supply in the secondary chemistry plays an irreplaceable role, in particular the emergence of valve-regulated batteries battery has the traditional glow of vitality. Battery life is closely related with the manufacture, and use the same time have great influence, the correct method to master the use of great benefit to extend battery life.
The traditional open-type batteries routinely on the following aspects NOTE:
① electrolyte quantity, density and charge level of attention and so, in particular, is closely related to the charging system with special care, if the battery charge level is greater water loss is more likely to cause the active material off the plate, causing the bottom of the short circuit to shortened battery life of the internal temperature is high, if the amount charged less likely to cause the battery’s loss electric, battery electric Zaichangqikui of situations, which can lead sulfate plate irreversible Hua, manifests itself Chongdianguocheng fast voltage Shangsheng , to complete a very short time, discharge voltage decreased rapidly.
② electrolyte purity, generally use the battery electrolyte, or add special fluid infusion, non-replaced with normal sulfuric acid and water.
③ the surface clean for everyday use, the exhaust port flow.
④ not be the first place full of electricity, while three months to conduct a supplementary power.
The sealed lead acid batteries are routinely on the following aspects NOTE:
① attention to the scope of float charge voltage when the voltage is usually controlled using 2.15 ± 0.1V / single cell, recycling of general control when the voltage at 2.35 ± 0.1V / single cell, if there are requirements specification should be instructions.
② Note the use of ambient temperature, generally not more than 30 degrees is appropriate. Higher temperature should enhance the voltage regulation.
③ products for different manufacturers can not be mixed, the same can not mix old and new product manufacturers.
④ sealed lead acid battery is best not to open the lid to add your electrolyte and replace safety valve.